Artiko MG-10A Digital Manifold Full Set – 88 Refrigerants, 800 psi, A2L Flame Icon, 3 Hoses

Artiko MG-10A is a digital manifold set that shows pressure, temperature, superheat and subcooling values on the same display for refrigeration and air conditioning service. 3 hoses and a carrying case are included — you can take it out of the box and go to the job site.

Work Without Memorizing PT Charts — Select the Refrigerant, Superheat and Subcooling Are on the Display

With an analog manifold, you read the pressure, then look at the refrigerant's saturation table and work out the temperature difference in your head. The MG-10A does this for you: the saturation curves of 88 refrigerants are stored in the device. You select the refrigerant from the list, the device calculates the saturation temperature for that refrigerant and displays the superheat and subcooling values directly.

In practice, this eliminates table look-ups and calculation errors in charging and fault diagnosis. Measurement time is noticeably shortened when adjusting expansion valves, charging capillary tube systems or diagnosing undercharge.

Technical Specifications (Product's Own Manual, Section 4.2)

• Model: Artiko MG-10A (marked as MG-10 on the device body and box; MG-10A is the set configuration with hoses)
• Pressure measuring range: −14.5 … 800 psi (from vacuum to high pressure with a single device)
• Pressure resolution: 0.5 psi
• Pressure accuracy: ±0.5 %FS
• Pressure units: kPa · MPa · psi · inHg · bar · kg/cm²
• Temperature unit: °C / °F
• Refrigerant library: 88 refrigerants (R410A, R32, R134a, R22, R404A, R407C and others)
• A2L warning: when a flammable (A2L) refrigerant is selected, a flame icon flashes on the display — a visual safety warning when working with refrigerants such as R32 and R454B
• Channels: 2-way (blue low pressure / red high pressure)
• Operating temperature: −10 … +50 °C | Storage: −20 … +60 °C | Humidity: 35% … 85% RH
• Power supply: 3 × AAA batteries, approximately 6 months of use
• Set contents: digital manifold body · 3 charging hoses · temperature probe · carrying case · user manual

• 🔧 Above 800 psi you will see OL on the display. This is not a fault but a warning that the measuring range has been exceeded — a note from the manual itself.
• When measuring superheat, the probe is attached to the suction line; when measuring subcooling, to the liquid line. Clamp the probe to the upper half of the line and always insulate it; otherwise the ambient temperature will distort the reading.
• ⚠️ With A2L refrigerants (R32, R454B, R1234yf), when the flame icon lights up on the display, pay attention to ventilation and sources of ignition.
• Battery warning: if you experience measurement deviation, first replace the batteries — low battery voltage causes drift in the pressure sensor.
• Vacuum monitoring: since it reads down to −14.5 psi, you can monitor the vacuum level with this device without a separate vacuum gauge.