Dechang YB30 Vacuum Cleaner Motor – 1200 W, 220-240 V, Arçelik Compatible

Dechang YB30 is a 1200 W vacuum cleaner suction motor. It operates on 220-240 V mains and is compatible with the motors of this size in Arçelik vacuum cleaners. With its standard Ø135 mm body size, it fits as a replacement in many vacuum cleaners of the same class.

24 kPa Vacuum, 3.2 m³/min Airflow

• 24 kPa maximum vacuum: Provides deep suction on surfaces such as carpets and rugs — this is the first value to drop when a motor wears out; a new one restores the vacuum cleaner's original suction.
• 3.2 m³/min airflow and 35% maximum suction efficiency — the upper band of this power class.
• Two-stage turbine: Aluminum fan housing and two-stage design produce higher vacuum at the same power.
• Class B insulation and temperature rise below 85 K — winding safety in long-term use.
• 50/60 Hz compatible: Operates regardless of mains frequency.

Technical Specifications, Dimensions and Replacement Notes

• Model: Dechang YB30  |  Product Code: S0008005
• Power: 1200 W (±10%)  |  Current: 5.60 A
• Voltage: 220 / 230 / 240 V  |  Frequency: 50/60 Hz
• Maximum Vacuum: 24 kPa  |  Maximum Airflow: 3.2 m³/min
• Maximum Suction Efficiency: 35%  |  Temperature Rise: <85 K
• Noise: 98 dB  |  Spark Class: <class 2  |  Insulation Class: B
• Dimensions: Outside diameter Ø135 mm  |  Body diameter Ø130 mm  |  Total height 115 mm  |  Fan housing height 33 mm
• Suction Inlet: Ø37 mm  |  Top Connection: Ø24 mm  |  Carbon Brush Cover Spacing: 118 / 84 mm (dimensioned drawing in the 2nd image)
• Compatibility: Arçelik (models with a 1200 W motor of the same size)

• 🔧 Measure the old motor before replacing. For vacuum cleaner motors, the deciding factor is not the power but the body diameter and height; if the Ø135 × 115 mm dimensions do not match, it will not fit in the housing.
• Always renew the gasket/felt: If the seal between the motor and the housing is damaged, vacuum leaks and suction stays weak with the new motor too.
• Clean the filter: A clogged HEPA/motor filter also strains the new motor and wears out the carbon brushes early.
• Connect the wire ends correctly; the motor has two terminals with no polarity, but a loose connection causes sparking.