Artiko RVG-10C Single-Valve Digital Manifold Full Set – 88 Refrigerants, With Hoses (With Case)

Artiko RVG-10C is a pocket-sized digital manifold / digital pressure gauge with a single body and a single valve. It measures pressure and temperature simultaneously; when you select the refrigerant from its built-in library of 88 refrigerants with NIST data, it calculates the superheat and subcooling values itself. This full set version comes in a carrying case with charging hoses, a clamp temperature probe and valve adapters — you can take it out of the box and start work right away.

Single-Valve Digital Manifold: Pocket-Sized Superheat/Subcooling Measurement

• Difference from an analog gauge: You don't turn a slide rule and read a P-T table; you select the refrigerant and the device calculates. ±0.5% FS accuracy and 0.5 psi resolution are much clearer than reading a needle.
• One valve, two jobs: Connects to the low or high side with a single line; charge/recovery control via the service valve is done with one hand. For small split servicing there is no need to carry a large two-valve manifold.
• Clamp probe included: Attaches to the pipe; pressure + pipe temperature are read together and superheat/subcooling is monitored live.
• Vacuum monitoring: Shows the negative pressure side (down to -14.5 psi); you monitor the evacuation of the system on the same device.
• 6 pressure units: kPa · MPa · psi · inHg · bar · kg/cm²  |  °C/°F selectable.

Technical Specifications, Set Contents and Usage Notes

• Product Code: 01 19 69  |  Model: Artiko RVG-10C (full set)
• Pressure Measurement: -14.5 ~ 800 psi · resolution 0.5 psi · accuracy ±0.5% FS
• Temperature Measurement: -50 ~ +150°C · resolution 0.1°C · accuracy ±0.5°C
• Refrigerant Library: 88 refrigerants (US NIST data) — including R32, R410A, R134a, R22, R404A, R407C
• Operating Temperature: -10 ~ +50°C · backlit display (LIGHT button) · ZERO function
• Set Contents: RVG-10 body + 2 charging hoses + clamp-type temperature probe + 2 valve adapters + carrying case + manual
• Warning: Cannot be used with ammonia (NH₃) refrigerants; compatible with non-corrosive refrigerants, water and glycol.

• 🔧 Zero before measuring — zeroing with the manifold unpressurized compensates for altitude/atmospheric pressure differences.
• Attach the clamp probe to bare copper; measuring over insulation skews the superheat calculation by 2-3°C.
• Do not leave the device on the line during pressure tests above 800 psi — the display shows "OL" and the sensor is strained.